Industrial boilers
Product thermal capacity: 4-35 t/h
Working pressure: 1.0-2.5 MPA
Outlet temperature: 184-350 ℃
Available fuel: natural gas, coke oven gas, bio-gas,liquid propane gas, diesel, heavy oil, light oil, crude oil
Available industries: Petroleum, chemical, chemical fiber, pharmaceutical, textile printing and dyeing, building materials, wood processing, vegetable oil processing and other industries
connected to turbine generator turbine and condenser have a three-pass round coil structure. A conical coil is used for the effective protection of the furnace wall at the boiler end. This product is equipped with an advanced combustion device and is fully automated in operation. After the burner ignites the fuel, flame fills the round coil tubes and transfers heat by radiation through the tube wall (first pass). The high temperature flue gas gathers at the back door and then turns to the convection tubes section (second pass), where heat transfer takes place by convection. The flue gas gradually cools down here and flows to the front door, where it is reversed and goes into the third pass. After that, it enters into the chimney through the economizer and is released into the atmosphere.
connected to turbine generator turbine and condenser.This type of heater is delivered as a whole, and is installed on site, it only needs to connect thermal gas(oil) piping and electricity to start operation. The heater has four heating areas: furnace radiation heating area, the first convection tube bundle heating area, the second convection tube bundle heating area and economizer (waste heat boiler).
2019-6-5 · CTMI, one of the leading Steam turbine manufacturers, situated in Hoskote, 25 kms from Bangalore, CTMI has, within a decade, rolled out a number …
lexie@zozen.com > Get A Quote >2019-9-15 · The thermodynamic cycle of the basic combined cycle consists of two power plant cycles. One is the Joule or Brayton cycle which is a gas turbine cycle and the other is Rankine cycle which is a steam turbine cycle. The cycle 1-2-3-4-1 which is the gas turbine power plant cycle is the topping cycle. It depicts the heat and work transfer process taking place in high temperature region.
lexie@zozen.com > Get A Quote >2018-4-4 · from the turbine into electricity. The turbine and generator rotors are aligned and directly connected. The turbine and generator are shown in Figure 3. n The condenser is attached to the low pressure end of the turbine. The condenser is a large vessel that condenses the turbine exhaust steam to improve the efficiency of the system.
lexie@zozen.com > Get A Quote >2006-1-27 · a condenser, a generator and a valving, wherein the high, medium and low pressure cylinders and the generator are mounted on concentric shafts; the condenser is the
lexie@zozen.com > Get A Quote >Water is heated, turns into steam and spins a steam turbine which drives an electrical generator. After it passes through the turbine, the steam is condensed in a condenser. Photovoltaic panels, wind turbines and binary cycle geothermal plants are also non-steam …
lexie@zozen.com > Get A Quote >2015-7-29 · capacitor bank is connected to compensate reactive power. the wind speed (10m/s) is such that the wind turbine produces enough power to supply the load. The diesel generator (not simulated) is stopped and the synchronous machine operates as a synchronous condenser with its mechanical power input (Pm) set at zero.
lexie@zozen.com > Get A Quote >2015-4-4 · to produce electricity from a generator that is connected to the turbine. The steam from the turbine is then condensed back into water in the condenser. The pump then returns the water to the injection wells. A condenser is a type of heat exchanger in which vapors are transformed into liquid state by removing the latent heat with the help
lexie@zozen.com > Get A Quote >IEC45-1 Steam Turbine Standard_/__ 2896217 IEC45-1 Steam Turbine Standard_/__。IEC45-1
lexie@zozen.com > Get A Quote >2019-9-16 · Steam Turbine. In general, a steam turbine is a rotary heat engine that converts thermal energy contained in the steam to mechanical energy or to electrical energy.In its simplest form, a steam turbine consist of a boiler (steam generator), turbine, condenser, feed pump and a variety of auxiliary devices. Unlike with reciprocating engines, for instance, compression, heating and expansion are
lexie@zozen.com > Get A Quote >2019-9-14 · Steam condenser is a device in which the exhaust steam from steam turbine is condensed by means of cooling water. The main purpose of a steam condenser in turbine is to maintain a low back pressure on the exhaust side of the steam turbine. After releasing from nozzles, the steam…
lexie@zozen.com > Get A Quote >2013-8-13 · the exhaust pipe 12 to a common or independent configuration 6 is connected to the condenser, and the wind turbine generator is connected to the frequency and
lexie@zozen.com > Get A Quote >