century pulp and paper chemical recovery plant pdf

Industrial boilers

Product thermal capacity: 4-35 t/h

Working pressure: 1.0-2.5 MPA

Outlet temperature: 184-350 ℃

Available fuel: natural gas, coke oven gas, bio-gas,liquid propane gas, diesel, heavy oil, light oil, crude oil

Available industries: Petroleum, chemical, chemical fiber, pharmaceutical, textile printing and dyeing, building materials, wood processing, vegetable oil processing and other industries

  • Product introduction
  • Technical advantages
Introduction

century pulp and paper chemical recovery plant pdf have a three-pass round coil structure. A conical coil is used for the effective protection of the furnace wall at the boiler end. This product is equipped with an advanced combustion device and is fully automated in operation. After the burner ignites the fuel, flame fills the round coil tubes and transfers heat by radiation through the tube wall (first pass). The high temperature flue gas gathers at the back door and then turns to the convection tubes section (second pass), where heat transfer takes place by convection. The flue gas gradually cools down here and flows to the front door, where it is reversed and goes into the third pass. After that, it enters into the chimney through the economizer and is released into the atmosphere.


century pulp and paper chemical recovery plant pdf.This type of heater is delivered as a whole, and is installed on site, it only needs to connect thermal gas(oil) piping and electricity to start operation. The heater has four heating areas: furnace radiation heating area, the first convection tube bundle heating area, the second convection tube bundle heating area and economizer (waste heat boiler).

Digitized manufacture
  • The laying-off of steel tube adopts CNC 3D laser cutting machine.
  • The manufacture of round coil tube adopts CNC coil tube automatic production line. Once-forming and no need for plastic .
Full argon arc welding
  • The tube butt adopts argon arc welding technique and the seams will be done x ray real-time imaging, preventing unqualified seams from entering coil production line .
Easy operation
  • Heater is wholly assembled before delivery, it is easy for installation, debugging and operating.
  • Fully automatic operating, burning, liquid level of high level tank, outlet temperature and flow rate are adjusted automatically and self-protected.
  • The inlet and outlet with end flanges and flanged cover structure facilitate the installation and layout of tubeline in boiler house.
Less fuel consumption
  • Internal side adopts good insulation material, outside uses stainless steel plate, which can mostly reduce heat lost and make working environment better.
  • Multilayers closely spaced tube bundle and steel rod is used to seal and fix, completely eradicating short circuit of flue gas.
  • Before delivery, the residue moisture is removed completely, so the system draining period is reduced to 2 days from 12 days.
Safely operation
  • The inner coil tube has bigger flow rate, so it is more stable under high temperature operation.
  • Conical coil effectively protects the furnace wall at the end of heater and burner on the top.
century pulp and paper chemical recovery plant pdf century pulp and paper chemical recovery plant pdf century pulp and paper chemical recovery plant pdf

Green Chemistry and Sustainability in Pulp and Paper

2017-8-29 · ucts, the pulp and paper industry faces many challenges and must Þ nd new ways to improve environmental and process performance and reduce operating costs. There has been a growing demand in the pulp and paper industry to adopt waste minimiza-tion strategies in order to create a minimum impact mill. A minimum impact mill

lexie@zozen.com > Get A Quote >

The Pulp and Paper Making Processes - Princeton Universi

2007-3-19 · THE PULP AND PAPER MILL Although there are several chemical and mechani-cal pulping methods used for delignifying wood (table 2-l), separating fibers, and removing discol-oration, all integrated pulp and paper mills involve the same general steps in the manufacture of pulp and paper. These steps include: 1 ) raw material

lexie@zozen.com > Get A Quote >

UF NF Treatment of Organic Laden Wastewater in

2016-12-9 · UF/NF TREATMENT OF ORGANIC LADEN WASTEWATER IN INDUSTRIAL PULP AND PAPER WASTEWATER Craig R. Bartels, PhD, Hydranautics, 401 Jones Road, Oceanside CA 92058, USA, Email: [email protected] Phone: 760-901-2617 Wayne Bates, Hydranautics Abstract The pulp and paper industry converts massive amounts of wood pulp into bright white paper.

lexie@zozen.com > Get A Quote >

Review Article Anaerobic Digestion and Biogas

2019-7-31 · Tertiary (physical-chemical) - Nutrient removal - Removing pathogens - Water reuse F : Flow scheme of general wastewater treatment of pulp and paper plant. Adapted from [ ]. e up ow anaerobic sludge blanket (UASB) reactor has been the most one used especially in those cases whose objective is the elimination or the conversion of the organic

lexie@zozen.com > Get A Quote >

(

2015-1-20 ·  whether the pulp and paper mill is equipped with a chemical recovery plant, the bleaching sequence employed and the efficiency of white water recycle in the paper

lexie@zozen.com > Get A Quote >

Paper Mill Design, Engineering & Constructi

Pulp & Paper. O'Neal is fully staffed and capable of providing design and construction services for the pulp and paper industry. We offer a full range of paper mill design, engineering, and construction services, as well as planning, design, procurement, and construction resources to effectively deliver a major capital investment or ongoing capital program management and support at an existing

lexie@zozen.com > Get A Quote >

Effect of Toxic Pollutants from Pulp & Paper Mill on Wate

2019-1-21 · was set-up in Kashmir in the 14th century. Much later, in 1832, the first mechanized The categorization of pulp and paper mills is based on the raw material used, plant size, and end products manufactured. The exact chemical composition of pulp and paper mill effluent is complex and unclear. The chemical compound found in pulp and paper

lexie@zozen.com > Get A Quote >

pulpapernews.com - News within the industry of pulp

News within the industry of pulp and paper, Sep, 18 2019. Latest News Ahlstrom-Munksjö explores strategic opportunities for its Decor paper business. Polish packaging maker to re-launch plant. New sheeting line starts up at Metsä Board's Äänekoski mill in Finland.

lexie@zozen.com > Get A Quote >

Paper Industry Wastes and Energy Generation From

Lime sludges from causticizing section of chemical recovery plant. (iii) Air pollution. In pulp and paper industry, air pollution is caused due to odor emitting reduced sulfur compounds such as hydrogen sulfide, methylmercaptan, dimethyl sulfide, and particulate matter SO 2 and NO x present in the gases emitted by different process units.

lexie@zozen.com > Get A Quote >

CHEMICAL MODIFICATION, PROPERTIES, AND USAGE OF

2017-8-29 · Chemical modification, properties, and usage of lignin/edited by Thomas Q. Hu. The pulp and paper industry not only produces an enormous amount of lignins as by­ from chemical pulping of non-wood plant materials have become increasingly more

lexie@zozen.com > Get A Quote >

The Mechanisms of Affecting Factors in Treating Wastewate

Ju Yan Chen Jiachuan Xue Rong (Shandong Key Laboratory of Pulp and Paper Engineering, Shandong Institute of Light Industry, Jinan,250353);Fenton Oxidation Process

lexie@zozen.com > Get A Quote >